Ps3 Move Eye Camera Manual

Posted on  by 



To dance and navigate the menus, all you need is a PlayStation Move motion controller. Put on the wrist strap and tighten it accordingly. Try to remain within view of PlayStation®Eye at all times.Your device's network configuration, showing the Manual (Static) IP you are using. Just Dance 2015. The PlayStation Eye is a USB camera that plugs into the PlayStation 3 system and captures video at a resolution of 640x480 at 60 frames per second. Those specifications translate into a very quick response time, meaning actions the PlayStation Eye perceives are displayed on the screen with minimal delay or lag source: Sony. PlayStation 3 Eye Camera & Move Controller Bundle (Accessories) by Sony. 5.0 out of 5 stars 1. PlayStation PlayStation 4 Camera (Old Model) ESRB Rating: Rating Pending Nov 15, 2013 by PlayStation. 4.5 out of 5 stars 2,077. Stand the camera tripod in the area where you want to monitor with the PS3 Eye video camera. Screw the tripod screw in the top of the tripod’s platform into the bottom mounting hole in the PS3 Eye.

General Knowledge – all you need to know before you start. Must read !

  1. Do not plug the camera to USB!
  2. Unplug all USB devices, leave only keyboard and mouse
  3. Only then, please download and install

PS3 Eye Camera Driver Installation

  1. If the camera has a cap, please remove it, If not – please carry on to point 2.
  2. Make sure your antivirus software is disabled while you will be installing the camera driver!
  3. Make sure you HAVE NOT PLUGGED the camera to your USB 2.0 port yet!
  4. Install the drivers – it is the CL-Eye Test program (it includes drivers too)
  5. Reboot the system
  6. Plug the camera direct to your motherboard USB 2.0 slot, DO NOT USE USB Hubs – very important.
  7. Wait for the system to update the registry
  8. You are good to go to the next step

Camera Check!

After installation of the drivers please make sure your camera is working with the “CL-Eye test” it is a program installed with the drivers. More in the next step.

Ps3

CL-Eye Test

This is built-in software delivered with the PS3 Eye camera PC drivers. You need to go to Menu and from DEVICES choose PS3 Eye Camera before you will be able to change anything.Then go to OPTIONS and click VIDEO CAPTURE FILTER to open the window. Please use it to pre-set your camera threshold before you go to set up the threshold in Opentrack. Please set your gain and exposure to get the results as similar to the video guide as you can.

Please note – if you are not satisfied with the LED dots size in your head tracking software you should remove the IR filter from your PS3 Eye camera. We do not guarantee perfect results until you have dedicated and properly modified camera.

Above video shows you how to start with mounting the DELANCLiP.
(please turn off any ad blocking software as this will hide the video)

Please view the below images for the idea of how to mount DelanClip.

You have the Delanclip Starter only – so which camera to choose?

It is always worth to trying any camera you actually have, before you go and buy another!

Please bear in mind, that the basic, unmodified cameras, never get the best performance when compared to 75 frames per second with PS3 Eye Camera.

This is the defining factor that is most important if you need very smooth movement translation into your favourite game.

There are many (recommended) cameras which will work great as a tracking receiver.

Unmodified cameras (not bought from us)

This only applies if you source the camera by yourself, our cameras does not need the below mod

If you will use the unmodified camera you have sourced it from somewhere else, make sure you have already fitted the 2 pieces of the transparent coloured film enclosed with the DELANCLiP on the top of the lens of your camera.

If you use your own (modified) camera without an IR filter – it is a must to use a bit of film from the floppy disk drive, otherwise, the camera will not function properly for head tracking.

OpenTrack Setup (Recommended - Easy)

Here is the easiest and free software to set up for head tracking with DELANCLiP

TrackIR Setup

TrackIR Camera is fully compatibile with DELANCLiP below is a link to a short video showing raeally easy setup.

General Knowledge – all you need to know before you start. Must read !

  1. Do not plug the camera to USB!
  2. Unplug all USB devices, leave only keyboard and mouse
  3. Only then, please download and install

PS3 Eye Camera Driver Installation

  1. If the camera has a cap, please remove it, If not – please carry on to point 2.
  2. Make sure your antivirus software is disabled while you will be installing the camera driver!
  3. Make sure you HAVE NOT PLUGGED the camera to your USB 2.0 port yet!
  4. Install the drivers – it is the CL-Eye Test program (it includes drivers too)
  5. Reboot the system
  6. Plug the camera direct to your motherboard USB 2.0 slot, DO NOT USE USB Hubs – very important.
  7. Wait for the system to update the registry
  8. You are good to go to the next step

Camera Check!

Manuals

After installation of the drivers please make sure your camera is working with the “CL-Eye test” it is a program installed with the drivers. More in the next step.

CL-Eye Test

Ps3 Eye Camera Specs

This is built-in software delivered with the PS3 Eye camera PC drivers. You need to go to Menu and from DEVICES choose PS3 Eye Camera before you will be able to change anything.Then go to OPTIONS and click VIDEO CAPTURE FILTER to open the window. Please use it to pre-set your camera threshold before you go to set up the threshold in Opentrack. Please set your gain and exposure to get the results as similar to the video guide as you can.

Please note – if you are not satisfied with the LED dots size in your head tracking software you should remove the IR filter from your PS3 Eye camera. We do not guarantee perfect results until you have dedicated and properly modified camera.

Above video shows you how to start with mounting the DELANCLiP.
(please turn off any ad blocking software as this will hide the video)

Please view the below images for the idea of how to mount DelanClip.

You have the Delanclip Starter only – so which camera to choose?

It is always worth to trying any camera you actually have, before you go and buy another!

Please bear in mind, that the basic, unmodified cameras, never get the best performance when compared to 75 frames per second with PS3 Eye Camera.

Ps3 Move Eye Camera Manuals

This is the defining factor that is most important if you need very smooth movement translation into your favourite game.

There are many (recommended) cameras which will work great as a tracking receiver.

Unmodified cameras (not bought from us)

This only applies if you source the camera by yourself, our cameras does not need the below mod

Ps3 Eye Camera Driver

If you will use the unmodified camera you have sourced it from somewhere else, make sure you have already fitted the 2 pieces of the transparent coloured film enclosed with the DELANCLiP on the top of the lens of your camera.

Ps3 Move Controller And Camera

If you use your own (modified) camera without an IR filter – it is a must to use a bit of film from the floppy disk drive, otherwise, the camera will not function properly for head tracking.

OpenTrack Setup (Recommended - Easy)

Here is the easiest and free software to set up for head tracking with DELANCLiP

Ps3 Eye Camera Pc

TrackIR Setup

Ps3 Move Eye Camera Manual User

TrackIR Camera is fully compatibile with DELANCLiP below is a link to a short video showing raeally easy setup.





Coments are closed